Keithley 2010 User Manual

Self-test 3-30
Sending and receiving data 4-5
Sending a response message 4-33
Sending and receiving data 4-5
[SENSe[1]] subsystem 5-37
Serial poll and SRQ 4-23
Service request enable register 4-22
Setting limit values 3-18
Setting line voltage and replacing fuse 2-9
Setting terminator 4-6
Shielding 2-18, 2-25
Short-form rules 4-30
Single channel (or channel pair) control 5-32
Single command messages 4-31
SPE, SPD (serial polling) 4-14
Specifications 1-3, A-1
Speed Commands 5-40
Status and Error Messages B-1
Status and error messages 2-16
Status Byte and Service Request (SRQ) 4-21
Status Byte Register 4-21
Status structure 4-16
STATus subsystem 5-54
Stepping and scanning trigger model
additions 3-22
Storing readings 3-16
Storing readings in buffer C-6
subsystem 5-37
System operations 3-30
T
Taking readings using the
READ? command C-12
Taking readings with the scanner card C-8
Temperature A-11
Testing diodes 2-37
Thermal EMFs 2-18
Thermocouple commands 5-50
Threshold resistance level 2-36
Timing 3-26
Trigger level 2-28
Trigger model 3-8
Trigger model (GPIB operation) 4-24
Trigger model operation 4-25
Trigger operations 3-8
Trigger subsystem 5-73
Typical command sequences E-11
U
Unaddress commands E-8
Uniline commands E-7
Universal multiline commands E-7
USER RTD Type 2-32
Using an internal scanner card 3-20
Using common commands and SCPI commands
in the same message 4-32
Using external scanner cards 3-20
Using OPEN and CLOSE keys 3-21
Using ratio with the relative function 2-21
Using SHIFT-CONFIG to configure stepping
and scanning 3-23
Using the
 and  keys 3-21
V
Voltmeter complete 3-12
W
Warm-up time 2-15
Warranty information 1-3

Keithley 2010 Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	3 A
DC Current Accuracy	0.05%
AC Current Range	3 A
Resistance Accuracy	0.01%
Interface	GPIB, RS-232
Power Supply	50 Hz or 60 Hz