Keithley 2010 User Manual

L
Limit operations 3-18
Line frequency query 5-70
Line power connection 2-8
LLO (local lockout) 4-13
LOCAL key 4-15
Long-form and short-form versions 4-29
Low level considerations 2-17
Low resistance measurements 2-25
Low thermal probes 1-5
M
Manual addenda 1-3
Manual ranging 3-2
Math 2-32
Maximum readings 3-2
MEASure command 5-5
Measurement configuration 3-2
Measurement Options 3-1
Measuring continuity 2-36
Measuring current 2-22
Measuring frequency and period 2-28
Measuring resistance 2-24
Measuring temperature 2-30
Measuring voltage 2-16
Measuring voltage with the SENSE
terminals 2-21
Message exchange protocol 4-33
Models 196/199 Commands D-1
Models 196/199 device-dependent command
summary D-2
Multiple channel control 5-34
Multiple command messages 4-31
Multiple response messages 4-33
mX + b 2-33
O
Offset compensation 2-26
One-shot triggering C-4
Optimizing measurement accuracy A-11
Optimizing measurement speed A-11
Options and accessories 1-4
Output queue 4-20
Output trigger 3-10
P
Percent 2-34
Power-on defaults 2-12
Power-up 2-8
Power-up sequence 2-10
Program examples C-2
Program message terminator (PMT) 4-32
Program messages 4-30
Programming syntax 4-27
Q
Query commands 4-29
Queues 4-20
QuickBASIC 4.5 programming 4-10
R
Rack mount kits 1-6
Range 2-37, 3-2
Range selection for ohms function D-6
Rate 3-6
Ratio 2-20
READ? command 5-4
Reading hold (autosettle) 3-10
Rear panel summary 2-6
Recalling readings 3-16
Relative 3-5
Remote Operation 4-1
REN (remote enable) 4-12
Response message terminator (RMT) 4-33
Response messages 4-33
Response time 3-4
ROUTe subsystem 5-32
RS-232 4-2
RS-232 connections 4-7
RS-232 interface commands 5-70
RS-232 operation 4-5
S
Safety symbols and terms 1-3
Scan operations 3-20
Scanner cards 1-4
Scanning examples 3-24
Scanning overview 3-20
SCPI 4-4
SCPI Command Reference 5-1
SCPI command subsystems reference
tables 5-6
SCPI commands E-9
SCPI signal oriented measurement
commands 5-2
SDC (selective device clear) 4-14
Selecting a language 4-3
Selecting an interface 4-2
Selecting baud rate 4-5
Selecting signal handshaking (flow control) 4-6
Selecting the primary address 4-10
Self-test 3-30

Keithley 2010 Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
DC Current Range	3 A
DC Current Accuracy	0.05%
AC Current Range	3 A
Resistance Accuracy	0.01%
Interface	GPIB, RS-232
Power Supply	50 Hz or 60 Hz