1. GENERAL INFORMATION
1-18
MXU 500
Tool Name Tool No.
Illustration
(Note: the special tools may differ
slightly from those shown in the
figure of this manual.)
Pinion bearing lock nut
wrench
(Refer to the “REAR DRIVE
DISASSEMBLY/INSPECTION/
ASSEMBLY” section in the chapter
13.)
A120F00020
Pinion puller
(Refer to the “REAR DRIVE
DISASSEMBLY/INSPECTION/
ASSEMBLY” section in the chapter
13.)
A120F00021
C-ring remover
(Refer to the “FRONT DRIVE
DISASSEMBLY/INSPECTION/
ASSEMBLY” section in the
chapter 13)
A120F00022
To Next Page
