1. GENERAL INFORMATION
1-17
MXU 500
Tool Name Tool No.
Illustration
(Note: the special tools may differ
slightly from those shown in the
figure of this manual.)
Crankshaft bearing puller A120E00068
Ball joint remover
(Refer to the “STEERING
KNUCKLE REMOVAL/
INSPECTION/
INSTALLATION” section in the
chapter 15)
A120F00012
Left pivot lock nut wrench
(Refer to the “REAR SWING
ARM REMOVAL/
INSTALLATION” section in the
chapter 15)
A120F00013
Joint yoke puller
(Refer to the “FRONT DRIVE
DISASSEMBLY/INSPECTION/
ASSEMBLY” section in the
chapter 13)
A120F00016
Drive shaft puller
(Refer to the “FRONT DRIVE
SHAFT REOMVAL/
INSPECTION/
INSTALLATION” section in the
chapter 13)
A120F00017
Yoke bearing puller
(Refer to the “FRONT DRIVE
DISASSEMBLY/INSPECTION/
ASSEMBLY” section in the
chapter 13)
A120F00018
(Cont’d)
To Next Page
