3. INSPECTION/ADJUSTMENT
3-26
MXU 500
Check the rear axle nut for looseness.
If the axle nuts are loose, tighten them to the
specified torque.
Torque:
Front: 7 kgf-m (70 N-m, 50 lbf-ft)
Rear: 10 kgf-m (100 N-m, 72 lbf-ft)
Inspect the tire surfaces.
Replace if wear or damage.
Tire wear limit: 4 mm (0.16 in)
WHEEL INSPECTION
Inspect the wheel.
Replace if damage or bends
Always balance the wheel when a tire or
wheel has been changed or replaced.
Rea
xNever attempt even small repairs to the
wheel.
xRide conservatively after installing a
tire to allow it to seat itself properly on
the rim.
＊
It is dangerous to ride with a worn out
tire. When a tire wear is out of
specification, replace the tire
immediately.
＊
To Next Page
Loading...
