11.FINAL REDUCTION/
TRANSMISSION SYSTEM
11-22
MXU 500
INSTALLATION
Make sure the shaft nut specified torque in
the V-belt compartment while holds the
stopper lever shaft.
Torque: 3 kgf-m (30 N-m, 21.6 lbf-ft)
Hook the spring onto the hook part of the
stopper lever, squeeze the spring in to the
groove of the left crankcase.
Install the washer and a new bolt.
Tighten the bolt to the specified torque while
holds the shaft nut in the drive V-belt
compartment.
Torque: 2.5 kgf-m (25 N-m, 18 lbf-ft)
Spring
Stopper Leve
To Next Page
