11.FINAL REDUCTION/
TRANSMISSION SYSTEM
11-23
MXU 500
Apply clean engine oil to the countershaft
assembly, driveshaft assembly and primary
drive shaft.
Install the primary drive shaft.
Install the countershaft and drive shaft
assemblies as a set into the left crankcase.
Apply clean engine oil to the shift cam, then
install the shift cam.
Apply clean engine oil to the gearshift fork,
sliding surface and gearshift fork pawl.
Install the lower gearshift fork into the clutch
dog (countershaft) and shift cam grooves with
its “LDB5” mark facing down.
Install the upper gearshift fork into the clutch
dog (countershaft) and shift cam grooves with
its “LDB5” mark facing up.
Drive shaft Assembly
Primary Drive Shaft Countershaft Assembly
Shift Ca
To Next Page
