LABORIE Goby Owner’s Manual GOBY-UM02 7
SYSTEM IMPORTANT INFORMATION
1. Use the Goby™ with LABORIE equipment and accessories only. Do not reuse disposable devices. After use,
dispose in accordance with local regulations. Do not use if device packaging has been opened, or damaged, or if
it presents any fault due to improper transport, storage, or handling that could in any way hamper its use.
2. The built-in pump is designed for use with water, saline or hypaque solutions only.
3. To prevent cross-contamination, waist belts and lanyards are made of machine washable materials and should be
washed with hot water and dried between uses.
4. To prevent the IV pole from dropping when mounted on the cart, ensure the pole is installed securely into the
pole mount and ensure the locking mechanism is securely fastened in place.
5. Be aware that prolonged use of video capture may result in elevated temperatures at the rear of the AIO PC.
6. Device intended for use in a clinical environment with controlled EMC standards to limit potential interference.
Goby™ may be adversely affected by Bluetooth®, cellular or EMC interference. Minimize interference from other
Bluetooth devices by setting up all components of system in proximity to each other.
SYSTEM SAFETY COMPLIANCE
1. To prevent unexpected exposure to radiation, the device has been tested against EN 60601-1-2 EMC standards.
2. To prevent exposure to potential electric shock, the device meets and exceeds the insulation breakdown
specifications for EN 60601-1, EN 60601-1-2 EMC standards & CSA 22.2 medical standards.
3. Warning symbols on all labels comply with EN ISO 15223-1 and EN 1041.
4. To prevent external injuries, patients and equipment operators are protected from moving parts of the pump
roller head by limiting the torque of the motor.
NOTE: local laws take priority over the above-mentioned requirements and warnings; if in doubt, consult your local
LABORIE representative or the technical service department.
To Next Page
Loading...
