LABORIE Goby - Types of Control Panel Commands

LABORIE Goby Owner’s Manual GOBY-UM02 75
5.8.6.4 Types of Control Panel Commands
The following table lists the types of control panel buttons available for the Goby™ software. Note that the button names
(labels) in the chart are suggestions and can be re-named.
Button Label
Definition
Type
Comments
First Sensation
First Desire
Capacity
Valsalva
Cough
First Sensation
First Desire
Capacity
Valsalva
Cough
Event
Marks an event with the
definition text as Event
Annotation.
Event -
Unique
An event that occurs
only once and will
replace any existing
recorded event.
Uroflow
CMG
Micturition
Full path of test CFG file
Config
Opens a .cfg file.
Slow Fill
Medium Fill
Fast Fill
XXX ml/min
+YY ml/min
-ZZ ml/min
SF
MF
FF
SP=XXX (where XXX is in ml/min)
SP+YY (where YY is the incremental
rate)
SP-ZZ (where ZZ is the decremental
rate)
Pump
Command
Controls the pump fill
rate.
Resume Pump
PumpRunStopResume
Pump
Command
Used with speed control
buttons. After the Stop
Pump button is clicked
the Resume Pump
button is enabled.
Auto Start
N/A
Auto Start
Sets up Uroflow Auto
Start.
Zero All
N/A
Zero All
Sets all channels to zero.
Pura = Pves or
Pabd = Pves
Channel X = Channel Y
Example: Pura channel = Pves
channel
Equalize
Sets the left channel
value to the right.
Patient Info
N/A
Patient Info
Opens Patient Info.
Plot
Pre-set with the selections made
when button is configured
Plot
†
Click the plot button to
open the Nomograms
that are applicable to
the test being
performed.
Stress Test
Stress Test
Stress Test
Command
For stress leak tests. Refer
to the Stress Events section
on page 56
for more
information.
UPP Return
UPP Pull
UPP Stop
IN (returns the puller as fast as
possible; for positioning the puller)
PU (
pulls at default UPP speed;
stops when it reaches the tip)
ST (stops the pull)
UPP
Command*
Refer to the
UPP Puller
manual for
more
information.
Controls the UPP puller
speed.