77
Orchestral & Solo
Still other buttons in this section control from where the sounds are played: Upper Keyboard and/or Lower
Keyboard. Orchestral and Solo volume controls are in this section, as well.
What It Does:
Going beyond what the Presets will do, you can experiment for an almost unlimited amount of possibilities
for “just the right sound.” Remember, if you find a combination you like, save it to a BANK PRESET.
How It Works:
The definition of Orchestral and Solo sounds and how they differ is important.
Red-colored
ORCHESTRAL sounds are Polyphonic. Polyphonic means you can play two or more notes at
the same time.
Blue-colored
SOLO sounds are Monophonic. Monophonic means you can only play one note at a time.
When multiple notes are being played, the Solo sound will always be heard on the highest note.
It is possible to play a Solo sound as if it were Polyphonic. Press the desired blue Solo button. Be sure the
red-colored
UPPER ON button is on (lighted) while the blue-colored UPPER ON and LOWER ON buttons are
OFF (not lighted). Pressing the blue-colored Upper On button, turning it on, will make the selected Solo
sound Monophonic.
NOTE: The red-colored UPPER ON button is lighted after you turn the organ on or press the Reset button.
How To Use It:
Listen to the Orchestral and Solo sounds to find your favorites. These sounds are beautiful alone or in com-
bination with the tab voices previously shown. Don’t forget about the hundreds of Genius Voices that can
be used in this section.
TRY THIS: Try the following example to sample the wide variety of Orchestral and Solo sounds.
1. Press the
RESET button.
2. Press the (Upper) FLUTE 16 and FLUTE 4 tabs, turning them off.
3. Press the red-colored
VIBES button.
4. Play notes on the Upper Keyboard to hear the Vibes sound.
5. Press the blue-colored
SCAT button.
6. Play notes on the Upper Keyboard to hear the Scat sound.
7. Follow these steps and select any sound you wish.
TRY THIS: Try the following example to sample the wide variety of Genius sounds available for the
Orchestral and Solo Genius 1 & 2 buttons.
1. Press the
RESET button.
2. Press the (Upper) FLUTE 16 and FLUTE 4 tabs, turning them off.
3. Press the red-colored GENIUS 1 button. The TOUCH SCREEN will display the sound assigned to the
Genius 1 button:
FRENCH HORN.
4. Play notes on the Upper Keyboard to hear the French Horn sound.
5. Press either SCROLL button one time. A different sound name will be displayed on the Information
Center screen.
6. Play notes on the Upper Keyboard to hear the sound displayed on the screen.
7. Continue pressing either Scroll button to display other sound names on the screen. When you see a
sound you want to hear, play some notes on the Upper Keyboard. There are hundreds of sounds from
which to choose.
To Next Page
Loading...
