Lucent Technologies MERLIN LEGEND Release 6.1 - Page 421

MERLIN LEGEND Communications System Release 6.1
Feature Reference 555-661-110
Issue 1
August 1998
Features
Page 372Integrated Administration
■ If the communications system and IS III are both being installed for the first
time, the technician must do some initial programming on the system, as
described in Step 1.
■ If IS III is being installed on an existing system, the technician skips Step 1.
To install, follow these general procedures:
1.
On installation of both the system and IS III , program the following basic
system operating conditions. SPM in surrogate mode is typically used for
this step, but the programming console also can be used.
■ Mode of operation (only Hybrid/PBX or Key for Integrated
Administration)
■ System renumbering
■ System operator positions
■ Phantom extensions
■ Assignment of lines/trunks to pools
2. Select
 $SSOLFDWLRQ6ZLWFK'HIDXOWV from the IS III Technician
Maintenance menu and, if necessary, change any of the values displayed
for the applications.
3. Select
([WHQVLRQ'LUHFWRU\6HWXS from the Technician Maintenance
menu. This step reads the system extension directory (including any labels
already programmed on the switch) into the application database.
4. Select
([WHQVLRQ'LUHFWRU\ and, on the resulting screens, program:
■ Assignment of extensions as AUDIX Voice Power subscribers; if
Fax Attendant is installed, this step also assigns the extensions as
Fax Attendant subscribers
■ Assignment of special-purpose extensions
■ Labeling of extensions
5. Select
6\VWHP3URJUDPPLQJ6ZLWFK$GPLQ from the AUDIX Voice Power
or AUDIX Voice Power/Fax Attendant menu, and program any of the
services below, as applicable.
NOTE:
During initial Integrated Administration programming for an existing
system, do not assign lines or pools to the calling groups set up for
services. If you do, lines begin ringing into the service before
greetings or other service options are programmed. Go on to Step 6
and finish programming the application; then return to Step 5 via the
System Programming/Switch Admin menu, and add lines and pools.