MERLIN LEGEND Communications System Release 6.1
Feature Reference
555-661-110
Issue 1
August 1998
Features
Page 416Messaging
At a Glance - Continued
Description 27
Messaging features allow users to do the following:
■ Send messages
■ Receive messages
■ Post messages
Sending Messages 27
The following features are used to send messages:
■ Send/Remove Message. For operators only.
■ Leave Message. For any user to leave a message for a co-worker with a
display telephone.
Send/Remove Message 27
The Send/Remove Message feature, available only to operators, turns the
Message LED on and off for any telephone connected to the local system. For
telephones without a display, Send/Remove Message is the only way the
Message LED can be turned on, unless either the extension is programmed as
the message-waiting receiver for a fax machine or calling group, or the system
has a voice messaging system connected (see “Direct Voice Mail” on page 237
).
NOTE:
In Release 6.0 and later systems (Hybrid/PBX mode only), Send/Remove
Message does not change the Message LED at a non-local extension.
A Send/Remove Message button is a fixed button on a Queued Call Console
(QCC) and cannot be reassigned. On a system with 29 or fewer lines,
Send/Remove Message is assigned by default to analog DLCs on button 34. On a
system with more than 29 lines, Send/Remove Message is replaced with line 32.
Maximums
Messages for each
display telephone
Message-Waiting
Receivers for fax
Message-Waiting
Receivers per
calling group
Fax Message
Threshold
10
4
1
10 seconds (range 0–30)
To Next Page
Loading...
Need help?
General
