Maeda MC405C-3 - Page 177

Mini-Crawler Crane M A E D A Section 4 – MODE SETTING OF THE TRANSMITTER
1/2019 MC405C-3 4-101
To switch the function item to another, or to
change the setting value of the function, use, the
Hook raising and lowering lever.
Then, to fix the value in the function, push the
hook Stow/Setting button.
Fig. 4-261
LCD Screen Contrast Ratio
CAUTION: The LCD screen may be illegible
when it is set too light or too dark, which may
prevent correct operations. Adjust its
contrast adequately for comfortable read.
Adjust the contrast ratio of the LCD screen:
Fig. 4-262
1. Shift the cursor ( or ) using the Hook
raising and lowering lever.
• To darken: Push the upper end of the
Hook raising and lowering
lever.
• To lighten: Push the lower end of the
Hook raising and lowering
lever.
2. When the desired contract is obtained, push
the Hook stow/Setting button. The condition
obtained in above 1. will be fixed and the
display returns to the A MODE screen.
Loudness Control (Available Only for Units
with Optional Voice Message)
Adjust the volume of voice messages:
Fig. 4-263
1. Shift the cursor ( or ) using the Hook
raising and lowering lever and select the
appropriate rate.
The volume adjust is by 6 steps, OFF, 1, 2,
3, 4, or ON.
The factory setting for this function is "MAX".
2. When the desired volume is obtained, push
the Hook stow/Setting button. The condition
obtained in above 1. will be fixed and the
display returns to the A MODE screen.
Acceleration
Adjust the engine speed limit, controllable by the
Accelerator lever:
Fig. 4-264
1. Shift the cursor ( or ) using the Hook
raising and lowering lever. When all the
bars lights, the speed limit is in maximum,
otherwise, when the all are OFF, it is in
minimum.
2. When the suitable rev limit is obtained, push
the Hook stow/Setting button. The value
obtained in above 1. will be fixed and the
display returns to the A MODE screen.