Mercedes-Benz Command - Comand

Basic functions
Switching COMAND on/off
X
Press the control knob on the center
console to the right of the controller.
When you switch on COMAND, a warning
message will appear. COMAND calls up the
previously selected menu.
If you switch off COMAND, playback of the
current media source will also be switched
off.
Adjusting the volume
Adjusting the volume for media sources
X
Turn the control knob on the center
console to the right of the controller.
or
X
Press the W or X button on the mul-
tifunction steering wheel.
The volume of the media source currently
selected changes.
Adjusting the volume for traffic
announcements and navigation
announcements
During traffic or navigation announcements:
X
Turn the control knob on the center
console to the right of the controller.
or
X
Press the W or X button on the mul-
tifunction steering wheel.
i
You can set the volume for navigation
announcements to be different from the
volume of the respective media source.
Adjusting the volume for phone calls
You can adjust the volume for hands-free
mode during a telephone call.
X
Turn the control knob on the center
console to the right of the controller.
or
X
Press the W or X button on the mul-
tifunction steering wheel.
i
Setting the volume for the Voice Control
System voice output, see the separate
operating instructions.
Switching the sound on or off
Media source sound
X
Press the 8 button on the multifunction
steering wheel.
i
If the audio output is switched off, the
status line will show the 8 symbol. If
you switch the media source or change the
volume, the sound is automatically
switched on.
i
Even if the sound is switched off, you will
still hear navigation system announce-
ments.
Switching navigation announcements
off and on again
X
To switch off navigation announce-
ments: press the 8 button on the mul-
tifunction steering wheel during the
announcement.
The Spoken
driving recommendations
have been deactivated. message
appears.
X
To switch navigation announcements
back on: switch COMAND off and then on
again (
Y page 30).
or
X
Start a new route calculation (Y page 65).
30
Basic functions
Overview and operation