Micromeritics ACCUPYC II 1345 User Manual

14 TEMPERATURE-CONTROLLED ACCUPYC
A temperature controlled AccuPyc must be connected to a circulating bath (not provided by
Micromeritics). Refer to the manufacturer operator manual for circulating bath operating instructions.
ATTACH A CIRCULATING BATH
The rear panel of the temperature-controlled AccuPyc contains connections for a circulating bath.
Provided in the accessory kit are two hose fittings and a four foot length of tubing.
1. Power off the controlling unit.
2. Remove the plugs from the In port and the Out port.
A. Circulating bath INport
B. Circulating bath OUTport
3. Insert the provided hose fittings into each connector.
4. Cut the piece of 4 ft. tubing into two equal pieces of 2 feet each.
5. Install the tubing on the In and Out connectors.
6. Install the other end of the Out tubing to the Inlet connection of the bath circulator.
7. Install the other end of the In tubing to the Outlet connection of the bath circulator.
8. Set the temperature using the appropriate controls on the bath circulator.
14 Temperature-Controlled AccuPyc
AccuPyc II 1345 Operator Manual
134-42851-01 (Rev A) — Jan 2021
14 - 1

Micromeritics ACCUPYC II 1345 Specifications

General

Brand	Micromeritics
Model	ACCUPYC II 1345
Category	Measuring Instruments
Language	English