Micromeritics ACCUPYC II 1345 - Page 90

6 Perform an Analysis
Display Text
Description
Analyze Sample Mass:
Enter a value for the sample mass. Displays only when Density is
selected for Analysis display mode. It does not display if Volume is
selected.
The range is 000.0000 to 10000.0000 g.
The range for the 2000 cm
3
AccuPyc is 000.0000 to 25000.0000 g.
This field will also accept input from a connected analytical balance.
While this prompt is displayed, press the appropriate button on the
analytical balance to transfer the mass (refer to the manufacturer’s
manual for the appropriate command).
Analyze Chamber
insert?
Select the insert to be used.
n None, 0.1 cm
3
(for 1 cm
3
unit)
n None, 3.5 cm
3
, 1.0 cm
3
(for 10 cm
3
unit)
n None, 35 cm
3
, 10.0 cm
3
(for 100 cm
3
unit)
n None, 650 cm
3
, 1300 cm
3
(for 2000 cm
3
pycnometer)
Press CHOICE until the appropriate insert is displayed or None if an
insert is not being used.
Analyze Cup Mass?
Enter the mass of the sample cup.
Analyze
[ENTER] to start
[ESCAPE] to cancel
ENTER. Starts the analysis. The analysis begins and operational
status messages are continually displayed during analysis
ESCAPE. Cancels the analysis.
For keypad and/or keyboard functions or commands not listed in this table,
seeAbout the Keypad on page2 - 3.
6 - 6
AccuPyc II 1345 Operator Manual
134-42851-01 (Rev A) — Jan 2021