Microsemi SyncServer S650 - Page 167

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 167
Chapter 5
SyncServer S6x0 CLI Command Set
|....|................................|....|................................|
|LAN3|2001:db9:ac10:fe10::2 |64 |2002:0DB9:AC10:FE10::1 |
|....|................................|....|................................|
|LAN4| |0 | |
-----------------------------------------------------------------------------
Example 2:
SyncServer> show ip status
Response 2:
Ethernet MAC
-------------------------
|Port|MAC |
|----|------------------|
|LAN1|00:B0:AE:00:36:0B |
|....|..................|
|LAN2|00:B0:AE:00:36:0C |
|....|..................|
|LAN3|00:B0:AE:00:36:0D |
|....|..................|
|LAN4|00:B0:AE:00:36:0E |
-------------------------
Eth Status-IPv4
---------------------------------------------------------
|Port|Address |Subnet Mask |Gateway |
|----|----------------|----------------|----------------|
|LAN1|192.168.107.122 |255.255.255.0 |192.168.107.1 |
---------------------------------------------------------
Eth Status-IPv6
-----------------------------------------------------------
|Port|Address |Pref|Gateway |
|----|--------------------------------|----|---------------|
|LAN4|2001::120 |64 | |
------------------------------------------------------------