Microsemi SyncServer S650 - Page 25

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 25
How to Use This Guide
What’s New In This Guide
The following corrections and additions have been made to the SyncServer S6x0
User’s Guide with Rev. D:
 Updated screen images for some Web Interface windows to reflect changes to
the GUI.
 Added details about new Low Phase Noise Module and Ultra Low Phase Noise
Module Chapter 1, Chapter 2 and Appendix B.
 Added details about dual DC power supplies to Chapter 1, Chapter 2 and
Appendix B.
 Added new alarms to Appendix A.
 Updated Software License information to include new licenses and new features
to existing license.
 Added new procedures to Chapter 6.
The following corrections and additions have been made to the SyncServer S6x0
User’s Guide with Rev. C, in addition to other changer.
 Added Configuring Network Timing Services, Mapping a Network Timing Service
to a LAN Port, Observing Status of Network Timing Services and Monitoring
Network Packets to Provisioning Outputs section in Chapter 6.
 Added information about IRIG with Flex Port Option
 Added PTP input/output details
 Added GPS/GLONASS/BeiDou antenna information
 Added GPS/GLONASS/BeiDou splitter information
The following corrections and additions have been made to the SyncServer S6x0
User’s Guide with Rev. B:
 Added v1.1 feature information NTP Reflector in NTP / PTP Services
Configuration Window section and in Security Features section.
 Updated image for Upgrading the Firmware section to show new Authentication
file required for firmware upgrade.
 Added new CLI commands for configuring serial timing output with NENA format:
set nena active, set nena-format, and show nene-format.
 Updated screen images for some Web Interface windows to reflect changes to
the GUI.