098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 257
Appendix A System Messages
System Notification Messages
PTP master switch 53 Notify Yes PTP Master switched No action required
PTP input not
time/freq traceable
54 Notify No PTP input time | freq not
traceable
PTP input time | freq not
traceable cleared
No action required
No action required
PTP state change to
disabled
75 Notify Yes PTP state changed to
disabled on LANx
No action required
PTP state change to
listening
76 Notify Yes PTP state changed to
listening on LANx
No action required
PTP state change to
master
77 Notify Yes PTP state changed to
master on LANx
No action required
PTP state change to
passive
78 Notify Yes PTP state changed to
passive on LANx
No action required
GNSS receiver
comms failed
91 Major No GNSS receiver
c o m m u n i c a t i o n s f a i l e d
GNSS receiver
communications
failure cleared
Reboot
If problem persists
call SGS for support.
No action required
GNSS receiver not
tracking satellites
92 Minor No GNSS receiver not
tracking satellites
GNSS receiver not
tracking satellites cleared
Check Antenna
installation
Check if Antenna
cable is connected
properly.
Installation should
conform to the
guidelines as
described in
Appendix C.
No action required
Table A-1. System Notification Messages (Continued)
Description
Event
ID
Msg
Level
Trans-
itory
MsgText Corrective Action
To Next Page
Loading...
