Microsemi SyncServer S650 - Page 262

262 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Appendix A System Messages
System Notification Messages
Synth unlock 137 Major No Synth unlock
Synth unlock cleared
 If alarm persists
power cycle/reboot
 Call SGS support if it
persists after
reboot/power cycle.
No action required
Rubidium unlock 138 Major No Rubidium unlock
Rubidium unlock cleared
 If alarm persists
power cycle/reboot
 Call SGS support if it
persists after
reboot/power cycle.
No action required
Temperature out of
range
139 Minor No Temperature out of range
Temperature out of range
cleared
Check your operating
environment.
No action required
Fan Failure 140 Minor No Fan failed - [A | B]
Fan failure cleared
 If alarm persists
power cycle/reboot
 Call SGS support if it
persists after
reboot/power cycle.
No action required
Timeline has been
changed
152 Notify Yes Timeline has been
changed
n/a
n/a
Phase has been
aligned
153 Notify Yes Phase has been aligned
n/a n/a
Table A-1. System Notification Messages (Continued)
Description
Event
ID
Msg
Level
Trans-
itory
MsgText Corrective Action