Minebea Intec PR 5230 - 4.4.6.3 Connecting to PLC

Weight type/plus or minus sign Description
Tare weight
Fixed tare
No display - Test value
- Gross, not tared
The display shows the test value without weight
unit.
Positive value
Negative value
Standstill/zero/dosing Description
Weight value standstill
The gross weight value is within ±¼ d of zero.
Filling mode; ashes when batching is stopped; ra-
pidashing indicates error.
Symbols/mass unit Description
Value not permissible in legal metrology
(e.g.,10-fold resolution, deactivated load cell).
R1 Range 1
R2 Range 2
R3 Range 3
t, kg, g, mg, lb, oz These weight units are available.
Note:
In the W&M mode an invalid weight without weight unit is shown.
3.4.3.3 Status display
For status indication on the device display, max. 5 lines can be congured by selecting
from a menu (see Chapter 7.15.7).
Selection Width Height Example Description
Empty ½ Display 1 line Blank
Gross/Net/Tare ½ Display 1 line B +123.45 kg
B E:Sense
Gross/Net/Tare
Error, see Chapter 16.1
Gross ½ Display 1 line B +123.45 kg Gross
Net ½ Display 1 line NET +123.45 kg Net
Tare ½ Display 1 line T +123.45 kg Tare
Transmitter in eld housing PR 5230 3 Device description
Minebea Intec EN-20