Minebea Intec PR 5230 - 16 Error messages; 16.1 Error messages measuring circuit

Note:
The GSD le is stored on the CD supplied with the device (eldbus directory of the
respective device). The current le is also available for download via the Internet.
http://www.minebea-intec.com
ProBus-DP terminal
Allocation of the 6-pole terminal block
Pin Assignment Signal Color Description
Cable sheath lila Special ProBus cable (certied)
1 ---------------------- VP Insulated voltage supply +5 V to RS-485 si-
de
2 ---------------------- DGND Insulated GND to RS-485 side
3 ---------------------- RxD/TxD-P
(negative) ac-
cording to
RS-485 speci-
cation
green Send/receive data
Data core A
4 ---------------------- RxD/TxD-P
(positive) ac-
cording to
RS-485 speci-
cation
red Send/receive data
Data core B
5 not connected
6 not connected
4.6.5.1 Controls on eldbus card
The terminating resistors can be switched on (ON) and o by pressing the bus ter-
mination switch ; see Chapter 4.6.5.3.
Transmitter in eld housing PR 5230 4 Device installation
Minebea Intec EN-80