Lynx Battery Replacement
Lynx II DSA User's Manual – 7096089 189
4. Remove and replace the battery on the MCA board.
5. Remove and Replace the RTC battery on Carrier Board. Insert Finger into the
opening and press down on the rear of the battery. Pull forward to remove the
battery.
6. Reassemble the unit.
7. Connect the Lynx II to power supply, detector, and computer/network. Connecting
to Genie will reset the RTC to the correct time. Refer to “Setting the Lynx II’s
System Time” on page 13 for directions on setting the correct time without using
Genie 2000.
To Next Page
Loading...
