Digital Oscilloscope
Lynx II DSA User's Manual – 7096089 85
Selecting the button to “On” ( ) will enable the digital oscilloscope main
screen while selecting the DSO button to the “Off” position
( ) will close the screen. Refer to Figure 44 on the next page.
Note: Enabling the DSO will disable the Time Series displayed by either the Aux
Counters or SCA if enabled.
To expand the DSO Time displayed, press the left mouse button down and drag the cursor
of the region to expand. The DSO will highlight the region. Release the left button.
To return the DSO to normal display, double click the left mouse button in the expanded
region.
Each digital signal waveform is displayed in different colors to distinguish between the
multiple traces. The waveform can be printed to a printer, depending on the capabilities of
your printer and the Internet browser you have chosen.
Figure 44: Digital Oscilloscope Main Screen
At the bottom are the settings that let you change the digital oscilloscope display. You can
also select the digital signals to view.
Any combination of digital signals can be selected or deselected depending on your
interest. Additionally, any one of the digital signals may be used as the Trigger in the
Trigger Options tab, where trigger options include Continuous, Single, or Manual
triggering.
To Next Page
Loading...
Need help?
General
