Motion Control Engineering 2000 User Manual

Index-4 Manual # 42-02-1P21
DSHTR, Door shortening (rear) flag 5-11
DSHTR, Door Time Shortening Rear Output (final) 5-42
DSL 1-20
DSTI, Door Stop Input 5-32
DSTIC, Door Stop Input Complement 5-32
DSTICR, Rear Door Stop Input Complement 5-32
DSTIR, Rear Door Stop Input 5-32
Duplex dispatcher (D) or a local (L) 5-98
Duplexing 5-108
DVR 1 IS OFFLINE message 6-12
DVR 2 IS OFFLINE message 6-12
DVR 2 MSSD FAILED ACTIVE message 6-12
DVR 3 IS OFFLINE message 6-12
DVR-’n’ Auxiliary starter timeout message 6-13
DVR-’n’ DOWN NORMAL LIMIT OPEN message 6-13
DVR-’n’ DOWN TERMINAL LIMIT FAILURE message 6-13
DVR-’n’ DRD (UP TO SPEED) FAILED TO ACTIVATE mes-
sage 6-13
DVR-’n’ DRD INPUT FAILURE message 6-13
DVR-’n’ EXCESSIVE NUMBER OF FAILED START AT-
TEMPTS message 6-13
DVR-’n’ M2L INPUT FAILURE message 6-13
DVR-’n’ MDFE FAILED TO ACTIVATE message 6-14
DVR-’n’ MDFE FAILED TO DEACTIVATE message 6-14
DVR-’n’ MDSE FAILED TO ACTIVATE message 6-14
DVR-’n’ MDSE FAILED TO DEACTIVATE message 6-14
DVR-’n’ MRD INPUT FAILURE message 6-14
DVR-’n’ MSSD FAILED TO ACTIVATE message 6-14
DVR-’n’ MSSD FAILED TO DEACTIVATE message 6-15
DVR-’n’ MTD FAILED TO ACTIVATE message 6-15
DVR-’n’ MTD FAILED TO DEACTIVATE message 6-15
DVR-’n’ MTM FAILED TO ACTIVATE message 6-15
DVR-’n’ MTM FAILED TO DEACTIVATE message 6-15
DVR-’n’ MTY FAILED TO ACTIVATE message 6-15
DVR-’n’ MTY FAILED TO DEACTIVATE message 6-15
DVR-’n’ MUFE FAILED TO ACTIVATE message 6-16
DVR-’n’ MUFE FAILED TO DEACTIVATE message 6-16
DVR-’n’ MUSE FAILED TO ACTIVATE message 6-16
DVR-’n’ MUSE FAILED TO DEACTIVATE message 6-16
DVR-’n’ OLM INPUT FAILURE message 6-16
DVR-’n’ OLM INPUT IS LOW message 6-17
DVR-’n’ RP SENSOR TRIPPED message 6-17
DVR-’n’ STARTER FAULT CONTACT OPEN message 6-17
DVR-’n’ STARTER TYPE ERROR message 6-17
DVR-’n’ UP NORMAL LIMIT OPEN message 6-17
DVR-’n’ UP TERMINAL LIMIT FAILURE message 6-17
DVR-’n’ YRD INPUT FAILURE message 6-17
DZ, Door zone input flag 5-11
DZF 6-42
DZORDZ, Front or rear door zone input flag 5-11
DZP, Door zone previous flag 5-11
DZR 6-42
DZR, Door zone input (rear) flag 5-11
DZRX, Door Zone Rear Auxiliary input 5-32
DZX, Door Zone Auxiliary input 5-32
E
Earthquake indicator output. 5-43
Earthquake Light 5-43
ECC, Excess car calls flag 5-11
ECRN, Emergency Car Freeze Input 5-32
ECRN, Emergency car run flag 5-11
ECRN, Emergency Power Car Run Output 5-42
EFG, Egress Floor Gong Output 5-43
EGRESS FLOOR ARRIVAL GONG option 5-28
Electrical noise 2-4
Elevator Shutdown Switch Active message 6-18
ELGO CAN channel loss 6-8
Eligibility Map, setting 5-106
Emergency Medical Operation 1-16
Emergency Medical Service message 6-18
Emergency Power message 6-18
Emergency Power Operation 1-18
Emergency Power Operation message 6-18
EMERGENCY POWER OPERATION? option 5-48
Emergency Power Return 5-40
EMERGENCY POWER RETURN FLOOR option 5-48
EMI/RFI problems 2-4
EMS SERVICE FLOOR # option 5-50
EMSB, Emergency Medical Service Buzzer Output 5-43
EMSC, Emergency Medical Service Car Switch input 5-32
EMSH, Emergency Medical Service Hall Switch input 5-32
EMSIC, Emergency Medical Service Car Indicator Output
5-43
EMSIH, Emergency Medical Service Hall Indicator Output
5-43
ENABLE FRONT DOB ON SECURITY? option 5-53
ENABLE REAR DOB ON SECURITY? option 5-53
ENCODE ALL FLOORS? option 5-48
English 5-72
Enter Security Code message 6-18
Environmental Considerations 2-3
EP1, Emergency Power Phase 1 Output 5-43
EP2, Emergency Power Phase 2 Output 5-43
EPI, Emergency Power Input 5-32
EPI, Emergency power input flag 5-11
EPR, Emergency power return flag 5-11
EPR, Emergency Power Return Input 5-32
EPRUN, Emergency Power Run Input 5-32
EPRUN, Emergency power run input flag 5-11
EPSTP, Emergency Power Stop Input 5-32
EPSTP, Emergency power stop input flag 5-11
EQH, Earthquake Hydro input 5-33
EQIND 5-43
EQL 5-43
error diagnostic display 5-99
ERU, Emergency Return Unit Input 5-33
ESC 6-41, 6-42
ESS, Elevator Shutdown Input 5-33
Ethernet 1-20
Event Calendar 5-71
EXCESSIVE FAULTS SHUTDOWN 6-7
EXCESSIVE NUMBER OF FAILED START ATTEMPTS mes-
sage 6-18
EXMLT Input Is Activated message 6-18
EXMLT message 6-18
EXMLT, External Motor Limit Timer flag 5-11
EXMLT, External Motor Limit Timer Input 5-33
EXMLTC, EXMLT Compliment Input 5-33
External Latching Fault 5-32

Motion Control Engineering 2000 Specifications

General

Brand	Motion Control Engineering
Model	2000
Category	Controller
Language	English