TRANSMISSION
Ch 2 page 26 Ch 2 page 27
TRANSMISSION
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
TRANSMISSION
Ch 2 page 26 Ch 2 page 27
TRANSMISSION
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
Display of the Cold-start phase: Transmission remains in Neutral
Bars are flashing: WK open
Error display: If the system is recognizing an error, the spanner (Spe-cial
symbol „g“) is flashing.
If Neutral is preselected on the Controller, a two-digit
error number appears on the two alphanumeric display
points (central and right Side).
If more than one error is pending, the different error
numbers will be indicated one after the other on the
Display in cycles (about 1 second).
The error code will --be only then indicated if
the Controller is in Neutral !
Warning display: At exceeding the warning threshold Temperature –
Sump / Retarder / behind the Converter and the war-ning
threshold Speed – Engine, changes the indication
on the Display to the actual gear and the corresponding
warning indicator.
If several warnings are simultaneously active,
only the warning with the highest priority will
be indicated.
W arning
indicator W arning Priority
W R Temp behind Retarder 1
W T Temp behind Converter 1
W S Temp in Sump 2
W E Engine speed 3
To Next Page
Loading...