Page 6 of 48
User Manual
Operation Instructions
Subject to modifications
2.1A-30008-A04
LINCOLN GmbH & Co. KG • Postfach 1263 • D-69183 Walldorf • Tel +49 (6227) 33-0 • Fax +49 (6227) 33-259
Safety Instructions, continuation
Operation, Maintenance and Repair, continuation
1013A94
ATTENTION!
Risk of bursting if the reservoir is overfilled!
When filling the reservoir by means of
pumps with a large delivery volume do not
exceed the max. filling mark.
CAUTION!
It is not allowed to use the pump in poten-
tially explosive fields.
Repair should only be performed by authorized and in-
structed personnel who are familiar with the instructions.
Lincoln Quicklub centralized lubrication systems
- must be operated only with installed pressure relief val-
ve.
- must be refilled in regular intervals with clean lubricant
recommended by the manufacturer without air entrap-
ments.
- operate automatically. However, a regular check (ap-
prox. every 2 days) should be made to ensure that
lubricant is emerging from all lubrication points.
Pump Models
1173a04
Fig. 1 Different models of pumps 223 (without) and 233 (with reading window)
Pumps 223 and 233 basically differ by the read-out function
((P223 without; P233 with). However, both pumps are avail-
able with all reservoir variants.
Reservoir sizes
2 l transparent plastic reservoir
4 l transparent plastic reservoir
8 l transparent plastic reservoir
Control unit models 223, 233
Pumps 223, 233 can be used with integrated control pa-
nels with monitoring of the metering device; pumps 233
additionally with data logger for the data transmission to
the Lincoln diagnostic software QuickData.
1)
Refer to the designation on the pump type plate, e.g.
P233 -2XLBO- 1 K6 - 24 - 2A6.15- MDF00 (see also chap-
ter “Identification Code” page 7 and 8).
For the following features of distinction please see the identi-
fication code on pages 7 and 8:
motor voltage
type of control unit (if any)
remote control for triggering an additional lubrication cycle
design and number of pump elements
design and number of pressure relief valves
filling type
use of return line connections
low-level control
Electrical connection
Pumps model 223, 233 may be equipped with a 10 m electric
cable.
To Next Page
Loading...