Moxy MT 31 - Introduction; ZF - Display

SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
Ch 2 page 57
TRANSMISSION
o.c. open circuit
s.c. short circuit
OP-Mode operating mode
TCU transmission control unit
EEC electronic engine controller
PTO power take off
ZF - Display:
If a fault is detected, the display shows a spanner symbol (g) for a fault.
The display shows the fault code, if the gear selector is on neutral position.
If more than one fault is detected, each fault code is shown for about 1 second.
Introduction
f
a
d
Left side
Right side
g
b
c
e
Abbreviations
Spec. charact. Display
a, f Autom atic range (up- and downshifting)
b, c, d, e Pres elected gear
g EST-37 has recognized an error, is flas hing
Left s ide
Shows engaged gear
Right side
Shows driving direc tion
Also, when the gear-selector is in neutral
, a two-di
g
it error code
will be shown via these two se
g
ments.