Ste
p to do Display message R
ema
r
k
1
warm up transmission normal operating messages
2
turn off ignition nothing
3
plug in AEB - starter
4
move shift lever to N
position
engage parkbrake
5
start engine ‘PL’ TCU must recognize PL for at least 2s
before you can press the button
6
set engine speed to low idle
rpm
‘PL’ if start conditions are ok
7
press button of the AEB-
Starter
‘ST’ if start conditions are ok The button must not be released before
TCU has started the AEB or quit with an
error code (see chapter 4)
8
hold button until AEB has
started
‘K1’ ...
(Information about the AEB
state)
TCU has started the AEB, and goes on
adjusting K1, K2, ..., KR.
(Button may be released)
9
wait until AEB has finished ‘OK’
(AEB has been successful)
10
turn off ingnition and unplug
AEB - Starter
nothing
To Next Page
Loading...