SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
TRANSMISSION
Ch 2 page 174 Ch 2 page 175
TRANSMISSION
TRANSMISSION
Ch 2 page 174 Ch 2 page 175
TRANSMISSION
Figure 179
Figure 182
Figure 181
Figure 180
Lift output shaft by means of pry bar until the bearing outer race is
free.
(S) Pry bar 504209
Pull bearing inner race off the shaft (Figure 182).
Press opposite bearing inner race off the shaft.
The separation of shaft and gear is not
possible (shrink fit)!
(S) Grab sleeve 504241
(S) Basic tool 504161
Pull bearing outer race out of the housing bore.
(S) Internal puller 504202
(S) Counter support 504201
Take output shaft out of the housing.
To Next Page
Loading...