SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
SHOP MANUAL MT26/31 - 08.2006 SHOP MANUAL MT26/31 - 08.2006
TRANSMISSION
Ch 2 page 256 Ch 2 page 257
TRANSMISSION
TRANSMISSION
Ch 2 page 256 Ch 2 page 257
TRANSMISSION
Figure 460
Figure 461
Adjust ball bearing by means of disc s = 4,0 mm, shim (option-
ally) and circlip without gap.
Insert ball bearing until contact is obtained.
Figure 463
Figure 462
Introduce pin until contact is obtained and fix it by means of
circlip.
Now, close bore with cover.
Observe the installation position of the pin –
thread for extraction is showing outwards.
Wet contact face of the cover with
Loctite (type-no. 262)!
Position compression spring, piston and shift fork.
Stop screw as well as rectangular ring will be
installed later!
To Next Page
Loading...