MUTOH Kona - Page 53

User’s Guide Kona cutting plotter
Basics
AP-75380 - Revision 1.2 53
3
Step 4: Make sure that about half of the sheet hangs in front of the machine and half hangs
at the back. This will make it easier to align the media correctly.
Step 5: Load the media straight. To help you, rulers are drilled in the front platen.
Step 6: Make sure that the media is cut off straight at the front to avoid media initialization
mismatches.
Step 7: Lower the pressure rollers.
Step 8: The cutter will measure the paper and displays a message:
Note
 Make sure not to get stuck on the pressure roller lever. This could damage your
clothes.
Note
 The head will move fast over the media. Be careful not to pinch your fingers
during this action.