Issue 2.0
SV9100 Networking Manual 4-27
50-03-01 CCIS Destination System Settings –
Destination Point Code
Assign the destination transfer point code for
Tandem KTS.
0 ~ 16367 Default = 0
50-03-03 CCIS Destination System
Settings – IP Address (IP
only)
Assign remote system IP network information
xxx.xxx.xxx.xxx
(xxx = 0 ~ 255)
Default is 0.0.0.0
Default = 0.0.0.0
84-26-01 IPLE Basic Setup – IP Address
Assign the IPLE IP Address.
XXX.XXX.XXX.XXX Default:
Slot 1 =
172.16.0.20
84-26-02 IPLE Basic Setup – RTP
Port Number
If needed the RTP port number can be set here.
0 ~ 65534 Default = 10020
84-26-03 IPLE Basic Setup –
RTCP Port Number
If needed the RTCP port number can be set
here.
(RTP Port Number + 1)
0 ~ 65534 Default = 10021
Program
Number
Program Name/Description Input Data Default
To Next Page
Loading...
General
