NEC Univerge SV9100 - Page 174

Issue 2.0
SV9100 Networking Manual 4-95
For Remote System
31-06-01 External Speaker Control –
Broadcast Splash Tone
before Paging (Paging Start
Tone)
0 = No Tone
1 = Splash Tone
2 = Chime Tone
Default is 2
Enable Splash Tone before paging.
31-06-02 External Speaker Control –
Broadcast Splash Tone
After Paging (Paging End
Time
0 = No Tone
1 = Splash Tone
2 = Chime Tone
Default is 2
Enable Splash Tone after paging.
31-06-03 External Speaker Control –
Speech Path
0 = Both Ways (Duplex)
1 = One Way
PGD  SPK (Simplex)
Default is 1
Establish whether or not the external speaker is
used for talkback.
(Not Available on CPU page port 9)
Program/
Item No.
Description/Selection Assigned Data Comments
Program/
Item No.
Description/Selection Assigned Data Comments
11-01-01 System Numbering Default is 51 = 2 digit: F-
Route
Assign also in PRG 11-12-20.
11-12-20 Service Code Setup (for
Service Access) – External
Paging
Default is 703 Change 703 Setting based on the K-CCIS network
configuration.
44-02-01 Dial Analysis Table for ARS/
F-Route Access) – Dial
Analysis Table 1 = 511
Default is No Setting
Assign the access code used to page.
Up to eight digits can be assigned.
44-02-02 Dial Analysis Table (ARS/F-
Route Access) – Service
Type
0= No Setting (None)
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table
(Option)
Default is 0
Assign Service Type.
44-02-03 Dial Analysis Table (ARS/F-
Route Access) –Additional
data
0= No Setting
1 = Delete Digits 0~255
(255: Delete All
Digits)
2 = 0~500
3 = Dial Extension
Analyze Table
Number (0~4)
Default is 0
For the Service Type selected in 44-02-02, enter
the additional data required.