NEC Univerge SV9100 - Page 193

Issue 2.0
4-114 Features and Specifications
20-11-12 Class of Service Options
(Hold/Transfer Service) –
Call Forwarding Off
Premise (External Call
Forwarding)
0 = Off
1 = On
Default is 0
Enable Call Forward – Off-Premise at an
extension.
20-11-13 Class of Service Options
(Hold/Transfer Service) –
Operator Transfer After
Hold Callback
0 = Off
1 = On
Default is 0
Turn Off or On an extension user ability to
have a call which recalls from hold transfer
to the operator.
20-11-14 Class of Service Options
(Hold/Transfer Service) –
Trunk-to-trunk Transfer
Restriction
0 = Off
1 = On
Default is 0
Enable Trunk-to-Trunk Transfer Restriction
at an extension.
15-07-01 Programmable Function
Keys 10 = Call Forward – Immediate
11 = Call Forward – Busy
12 = Call Forward – No Answer
13 = Call Forward – Busy/No
Answer
Service Codes:
741
742
743
744
14-01-13 Basic Trunk Data Setup –
Trunk-to-Trunk Transfer
Loop Supervision
0 = Disable (No)
1 = Enable (Yes)
Default is 1
Must be enabled for Trunk-to-Trunk
Transfer, Call Forward – Off-Premise, and
Tandem Trunking.
14-01-22 Basic Trunk Data Setup –
Caller ID to Voice Mail
0 = Disable (No)
1 = Enable (Yes
Default is 0
Enable the system to send Caller ID Digits
to Voice Mail.
22-02-01 Incoming Call Trunk Setup 0 = Normal
1 = VRS (second dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie Line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode Switching
Default is 0
Set the feature for the trunk being
programmed.
22-07-01 DIL Assignment Extension Number/ Pilot Number
(eight digits maximum)
Default is No Setting
Assign destination extension or Department
Group pilot number programmed in PRG
11-07.
Program/
Item No.
Description/Selection Assigned Data Comments