NEC Univerge SV9100 - Page 278

Issue 2.0
4-14 Programming
13
Loss-Of-Signal Detection Limit
If the transmit/receive voltage is less
than the setting in 10-03-13, the system
considers this as Loss-Of-Signal and
the PRTA does not come up. Note that
there are different values based on the
setting in 10-03-12 for the PRI.
0 = Level 0 (lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7 (highest sensitivity)
2
14
--- Not Used ---
15
--- Not Used ---
16
--- Not Used ---
17
--- Not Used ---
18
Type of Number
ISDN Protocol definition.
Select the number type for the ISDN
circuit.
0 = Unknown
1 = International number
2 = National number
3 = Network Specific number
4 = Subscriber number
5 = Abbreviated number
0
19
Numbering Plan Identification
ISDN Protocol definition.
Select the Numbering Plan used for the
ISDN circuit.
0 = Unknown
1 = SDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering
plan
5 = Private numbering plan
0
20
Network Exchange Selection
Select the ISDN protocol for the ISDN
circuit.
0 = Standard (same as NI-2)
1 = reserved
2 = reserved
3 = DMS (A211)
4 = 5ESS
5 = DMS (A233)
6 = 4ESS
7 = NI-2
0
21
Number of Ports
0 = Auto
1 = 4 Ports
2 = 8 Ports
3 = 12 Ports
4 = 16 Ports
5 = 20 Ports
0
22
--- Not Used ---
Item
No.
Item Input Data Default