NEC Univerge SV9100 - Page 277

Issue 2.0
SV9100 Networking Manual 4-13
For PRTA PKG Setup
ISDN Line Number 01~24
Item
No.
Item Input Data Default
01
--- Not Used ---
02
Logical Port Number
 The start port number of a PRI line
is displayed.
1 = for T-Bus 1~400
1
03
--- Not Used ---
04
Layer 3 Timer Type
 Each timer value of Layer 3 is set up
for each type in
Program 81-06 (T-Bus)
1~5
1
05
CLIP Information
Based on this setting, the system
includes a Presentation Allowed (1) or
Presentation Restricted (0) in the Setup
message to allow or deny the Calling
Party Number. Program 15-01-04 must
also be set to 1 if this option is enabled.
0 = Disable
1 = Enable
1
06
Length of Cable
0 = Level 1
1 = Level 2
2 = Level 3
3 = Level 4
4 = Level 5
2
07
--- Not Used ---
08
Dial Sending Mode
ISDN Protocol definition
0 = Enbloc Sending
1 = Overlap Sending
1
09
Dial Information Element
ISDN Protocol definition
(Only when Dialing Sending Mode
(10-03-08) is set for 1 (Overlap
Sending)
0 = Keypad Facility
1 = Called Party Number
0
10
--- Not Used ---
11
--- Not Used ---
12
--- Not Used ---