NEC Univerge SV9100

Issue 2.0
4-36 Programming
43
Video Mode
0 = Disable
1 = Enable
0
This Program is used to
select the video function with
the standard SIP terminal. If
the standard SIP terminal
supports the video function,
the SV9100 transfers the
video CODEC in SDP
information.
44
Using
Standard SIP
Display for
CPN
0 = Disable
1 = Enable
0
This Program is used to
Enable or Disable the
system to send INVITE from
tag Display attribute which is
sent from a standard SIP
terminal as CPN to ISDN,
and if there is no Display
attribute from standard SIP
terminal, the system will not
refer to either PRG 21-12-01
or 21-13-01 and no CPN will
be sent.
45
NAT Plug &
Play
0 = Disable
1 = Enable
0
Select sending RTP port
number to remote router. (0)
uses result from negotiation
result, (1) from received RTP
packet. Effective only when
10-46-14 is to NAT Mode.
10-46-14
46
Door Phone
Number (Read
Only)
0 = Not assigned
1 ~ 8 = Door Phone
Number
0
Indicates automatically
assigned IP Door Phone
Number after system
registers the Door Phone
port. System assigns the
number not to duplicate with
the Door Phone connected
to PGD(2)-U13. (Read
Only)
10-03
(DLCA)
PGD
47
Registration
Expiration
Timer for NAT
0 = Disable
60 ~ 65535(sec)
180
On a per station basis, this
setting defines the SIP
registration expiry timer. If
this value is set to 0, for a
NAPT terminal, the value in
PRG 84-23- 01 is applied.
10-46-14
48
Subscribe
Expire Timer
for NAT
0 = Disable
60 ~ 65535(sec)
180
On a per station basis, this
setting defines the SIP
Subscribe expiry timer. If this
value is set to 0, for a NAPT
terminal, the value in PRG
84-23-02 is applied.
10-46-14
Item
No.
Item Input Data Default Description
Related
Program