NEC Univerge SV9100 - Page 355

Issue 2.0
SV9100 Networking Manual 6-9
10-12-11 GCD-CP10 Network Setup – NIC Setup
Define the LAN interface Speed and Mode of
the VoIP Application supported.
 IPLE daughter board does not support half
duplex connection.
0 = Auto Detect
1 = 100Mbps, Full Duplex
3 = 10Mbps, Full Duplex
5 = 1Gbps, Full Duplex
0

10-19-01 VoIP DSP Resource Selection
Select type of GPZ-IPLE DSP Resource. This
program setting has no affect on the terminal/
trunk port assignment or usage.
0 = Common use for both IP
extensions and trunks
1 = IP Extension
2 = SIP Trunk
3 = CCIS/Networking
4 = Use for NetLink
5 = Blocked
6 = Common without Unicast
Paging
7 = Multicast Paging
8 = Unicast Paging
0

10-23-01 SIP System Interconnection Setup – System
Interconnection
Determine if the system is interconnected to
another system.
0 = No (Disable)
1 = Yes (Enable)
0

10-23-02 SIP System Interconnection Setup – IP
Address
Define the IP Address of the SIP System
Interconnection.
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
0.0.0.0

10-23-04 SIP System Interconnection Setup – Dial
Number
Define Dial Number for the SIP System
Interconnection.
Maximum of 12 digits. No Setting

10-23-06 SIP System Interconnection Setup – SIP
Profile
Assign the Interconnection to a SIP Profile.
1 = Profile 1
2 = Profile 2
1

10-28-01 SIP System Information Setup – Domain
Name
Define the Domain name. This information is
generally provided by the SIP carrier.
Maximum of 64digits.
(Profile 1 ~ Profile 2)
No Setting

10-28-02 SIP System Information Setup – Host Name
Define the Domain name. This information is
generally provided by the SIP carrier.
Maximum of 48 digits.
(Profile 1 ~ Profile 2)
No Setting

10-28-03 SIP System Information Setup – Transport
Protocol
Define the Transport type. This option is always
set to UDP.
0 = UDP
1 = TCP
(Profile 1 ~ Profile 2)
0

Program
Number
Program Name/Description Input Data Default
Level
1 2 3