NEC Univerge SV9100 - Page 443

Issue 2.0
8-52 IP Multiline Station (SIP)
10-46-01
DT800/DT700
Server Information
Setup – Register
Mode
Define which of the three
Registration modes you wish the
SIP MLTs to use.
Normal
When the phone boots up it will
report the ext assigned in the phone
or choose the next available
extension in the system. No
password required.
Auto
If set to auto then the SIP user
name and password must be
entered into the actual IP phone.
These settings have to match
Programs 84-22/15-05-27 or the
phone does not come on-line.
Manual
When the phone boots up it prompts
you to enter a user ID and password
before logging in. It checks this user
ID/password against Programs 84-
22/15-05-27. If there is not a match,
the phone does not come on-line.
0 = Normal
1 = Automatic
2 = Manual
Default is 0
X
10-46-04
DT800/DT700
Server Information
Setup – Server
Name
USER ID of the SIP URL if Program
10-46-05 is set to domain name.
A SIP URL is made up of three
parts. Domain name, host name,
and server name.
e.g. At default the server name is
sipphd. The URL could look like the
following:
sipphd@voipu.nec.com
Up to 32 characters.
Default is sipphd
X
10-46-06
DT800/DT700
Server Information
Setup – Register
Port
Port the SIP messages are sent to
on the VoIPU card. This same port
number must be assigned in the SIP
Multiline terminals.
Changing this command also
requires a CPU reset.
Range = 0 ~ 65535
Default is 5080
X
10-46-07
DT800/DT700
Server Information
Setup – Encryption
Mode
Enable or disable encryption mode.
0 = Off
1 = On
Default is 0
X
Program
Number
Program Name Description/Comments Assigned Data 1 2 3