NEC Univerge SV9100 - Page 444

Issue 2.0
SV9100 Networking Manual 8-53
10-46-08
DT800/DT700
Server Information
Setup – Encryption
Type
Assign the encryption type.
0 = Mode 1
Default is 0
X
10-46-09
DT800/DT700
Server Information
Setup – One-Time
Password
Password used when Program
10-46-07 is set to ALL. Assign a
character string of 10 characters or
less.
Valid Characters
(0~9, *, #)
Default Not assigned
X
10-46-10
DT800/DT700
Server Information
Setup – Start Port
With Automatic logon the starting
port number for automatic port
allocation.
Range = (1 ~ 960)
Default = 1
X
15-05-01
IP Telephone
Terminal Basic Data
Setup – Terminal
Type
Type of IP terminal registered with
the specified extension number.
1 = H.323
2 = SIP
3 = None
4 = DT800/DT700
X
15-05-02
IP Telephone
Terminal Basic Data
Setup – IP Phone
Fixed Port
Assignment
Allow association of a MAC Address
to an extension. When the IP phone
sends a register message to the
CPU the CPU responds back with
the extension number associated to
the MAC address.
00.00.00.00.00.00~
FF.FF.FF.FF.FF.FF
Default is
00.00.00.00.00.00
X
15-05-07
IP Telephone
Terminal Basic Data
Setup – Using IP
Address
IP address the IP Terminal is using
for the specified extension number.
0.0.0.0~
255.255.255.255.
Default is 0.0.0.0
X
15-05-15
IP Telephone
Terminal Basic Data
Setup –CODEC
Type
Assign CODEC type for IP Terminal.
If SIP SLT, use Program 84-19. If
SIP MLT, use Program 84-24.
1 = Type 1
2 = Type 2
3 = Type 3
4 = Type 4
5 = Type 5
1 = Default is 1
X
15-05-19
IP Telephone
Terminal Basic Data
Setup – Side Option
Information
Read Only CM showing type of Line
Key unit installed on the telephone.
0 = No Option
1 = 8LK Unit
2 = 16LK Unit
3 = 24ADM
Default is 0
READ ONLY
X
15-05-20
IP Telephone
Terminal Basic Data
Setup –Bottom
Option Information
Read Only CM showing type of
adapter installed on the telephone.
0 = No Option
1 = ADA
2 = BHA
4 = BCA
Default is 0
READ ONLY
X
Program
Number
Program Name Description/Comments Assigned Data 1 2 3