Issue 2.0
10-54 SV9100 NetLink
MIC
Press MIC to switch between the different input data fields. The cursor
moves up to the top row of the display. Press
MIC again to move the
cursor back to the middle row.
LINE KEYS
Use programmed settings to help with the program entry. These settings
vary between programs from LINE 1 = 0 (off) and LINE 2 = 1 (on) to preset
values for timers where LINE 1 = 5, LINE 2 = 10, LINE 3 = 15, etc.
For programs with this option, the line key, which currently matches the
programmed setting, lights steady.
The display can also indicate Softkey, which will allow you to select the
values as well (-1 and +1 will step through these pre-programmed
settings.)
LINE KEY 1
Program a pause into a Speed Dialing bin.
LINE KEY 2
Program a recall/flash into a Speed Dialing bin.
LINE KEY 3
Program an @ into a Speed Dialing bin.
VOL
Scroll backward through a list of entry numbers (e.g., from extension
etc.) or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data
before scrolling forward.
VOL
Scroll forward through a list of entry numbers (e.g., from extension
etc.) or through entries in a table (e.g., Common Permit Table).
If you enter data and then press this key, the system accepts the data
before scrolling backward.
Table 10-4 Keys for Entering Data (Continued)
Keys for Entering Data
Use this key... When you want to...
To Next Page
Loading...
