Issue 2.0
13-80 AspireNet
Description
Use Program 10-32 : PRI Networking Maximum PRI Channel Setup to assign the number of B-
channels to be used for each ISDN blade. This allows for fractional PRIs when used with multiple site
networking.
If this program is limited to less than "30" on one side of the network, then it also limits both inbound and
outbound network calls. For example, when you select 10 channels then only channels 1 to 10 will be
available. If a call is attempted on channels 11 to 30 the caller will receive busy tone. This also applies on
the other side of the network as well.
The setting is for each slot within the SV9100; ensure that you select the correct slot before making any
changes.
This program will not affect a PRI card set as Trunk or Station mode.
Conditions
None
Feature Cross Reference
Networking - AspireNet
Program 10 : System Configuration Setup
10-32 : Networking Maximum PRI Channel Setup
Level:
IN
Input Data
Slot Number 1-24
Item
No.
Item Input Data Default
01
Maximum Channels
Set the maximum number of channels
which can be used with PRI NetLink.
1 - 30
30
To Next Page
Loading...
