Introduction
14
NETGEAR ProSAFE VPN Firewall FVS318G v2
The front panel also contains three groups of status indicator light-emitting diodes (LEDs),
including Power and Test LEDs, LAN LEDs, and WAN LEDs, all of which are described in
detail in the following table. Some LED explanation is provided on the front panel.
Figure 2. Front panel
The following table describes the function of each LED.
Table 1. LED descriptions
LED Activity Description
Power LED On (green) Power is supplied to the VPN firewall.
Off Power is not supplied to the VPN firewall.
Test LED On (amber) during
startup
Test mode. The VPN firewall is initializing. After approximately two minutes,
when the VPN firewall completes its initialization, the Test LED turns off.
On (amber) during
any other time
The initialization failed, or a hardware failure occurred.
Blinking (amber) The VPN firewall is writing to flash memory (during upgrading or resetting to
defaults).
Off The VPN firewall booted successfully.
Power
Test LED
DMZ LED
Left WAN LED
Right WAN LED
Active WAN LED
LED
Left LAN LEDs
Right LAN LEDs
(green, one for each port)
(one for each port)
(green)
To Next Page
Loading...
