Virtual Private Networking Using IPSec and L2TP Connections
237
NETGEAR ProSAFE VPN Firewall FVS318G v2
2. Select VPN > Connection Status.
The Active IPSec SA(s) table lists e
ach active connection with the information that is
described in the following table.
3. T
o change the poll interval period, enter a new value in the Poll
Interval field, and click the
Set Interval button.
The default poll interval is 10 seconds.
4. To stop polling, click the St
op button.
View the VPN Firewall IPSec VPN Log
To display the IPSec VPN log:
1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter
https://192.168.1.1.
The NETGEAR Configuration Manager Login screen d
isplays.
b. In the Username
field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your personalized
password. Leave the domain as it is (geardomain).
Table 49. IPSec VPN Connection Status screen information
Item Description
Policy Name The name of the VPN policy that is associated wi
th this SA.
Endpoint The IP address on the remote VPN endpoint.
Tx (KB) The amount of data that is transmitted over this SA.
Tx (Packets) The number of IP packets that are transmitted over this SA.
State The status of the SA. Phase 1 is the authentication phase, and Phase 2 is key
exchange phase. If no connection exists, the status is IPSec SA Not Established.
Action Click the Connect table button to build the connection, or click the Disconnect table
button to terminate the connection.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
