Firewall Protection
147
NETGEAR ProSAFE VPN Firewall FVS318G v2
The Router Status screen displays. After five minutes of inactivity, which is the default
login time-out, you are automatically logged out.
2. Select Security
>
Firewall > DMZ WAN Rules.
The Firewall submenu tabs display with the DMZ W
AN Rules screen for IPv4 in view.
3. To view the DMZ WAN Rules screen for IPv6 rules, in the upper right
of the screen, select
the IPv6 radio button.
4. Select the check box to the left of each rule that you want to e
nable, disable, or delete, or
click the Select All table button to select all rules.
5. Click one of the following table buttons:
• Enable
. Enables the rule or ru
les. The ! status icon changes from a gray circle to a
green circle, indicating that the selected rule or rules are enabled. (By default, when a
rule is added to the table, it is automatically enabled.)
• Dis
able. Disable
s the rule or rules. The ! status icon changes from a green circle to a
gray circle, indicating that the selected rule or rules are disabled.
• Delete. Deletes t
he selected rule or rules.
6. Click the Ap
ply button.
Your changes are saved.
Create DMZ WAN Outbound Service Rules
You can change the default outbound policy or define rules that specify exceptions to the
default outbound policy. By adding custom rules, you can block or allow access based on the
service or application, source or destination IP addresses, and time of day. An outbound rule
can block or allow traffic between the DMZ and any external WAN IP address according to
the schedule created on the Schedule screen.
IPv4 DMZ WAN Outbound Service Rules
To create an IPv4 DMZ WAN outbound rule:
1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter
https://192.168.1.1.
The NETGEAR Configuration Manager Login screen d
isplays.
b. In the Username
field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your personalized
password. Leave the domain as it is (geardomain).
c. Click
the Logi
n button.
The Router Status screen displays. After five minutes of inactivity
, which is the default
login time-out, you are automatically logged out.
2. Select Security >
Firewall > DMZ WAN Rules.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
