NETGEAR FVS318G - Set Limits for Ipv4 Sessions

Firewall Protection
173
NETGEAR ProSAFE VPN Firewall FVS318G v2
• Respond to Ping on Internet Ports. Select this check box to enable the VPN firewall
to respond to a ping from the Internet to its IPv6 address. A ping can be used as a
diagnostic tool. Keep this check box cleared unless a specific reason exists to enable
the VPN firewall to respond to a ping from the Internet.
• IPsec.
Select this check box to enable IPSec VPN traffic that is initiated from the LAN
to reach the WAN, irrespective of the default firewall outbound policy and custom
firewall rules.
5. Click the Ap
ply button.
Your changes are saved.
Set Limits for IPv4 Sessions
You can specify the total number of sessions that are allowed, per user, over an IPv4
connection across the VPN firewall. The session limits feature is disabled by default.
 To enable and configure session limits:
1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter
https://192.168.1.1.
The NETGEAR Configuration Manager Login screen d
isplays.
b. In the Username
field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your personalized
password. Leave the domain as it is (geardomain).
c. Click the Logi
n button.
The Router Status screen displays. After five minutes of inactivity
, which is the default
login time-out, you are automatically logged out.