Firewall Protection
172
NETGEAR ProSAFE VPN Firewall FVS318G v2
4. Click the Apply button.
Your changes are saved.
IPv6 Attack Checks
To enable IPv6 attack checks for your network environment:
1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter
https://192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
b. In the User
name field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your persona
lized
password. Leave the domain as it is (geardomain).
c. Click
the L
ogin button.
The Router Status screen displays. After five minutes of inactivity,
which is the default
login time-out, you are automatically logged out.
2. Select Securi
ty > Firewall > Attack Checks.
The Attack Checks screen displays.
3. In the upper right of the screen, select the IPv6
radio button.
4. Configure the following settings:
Jumbo Frames
Enable Jumbo
Frame
Jumbo frames allow multiple smaller packets to be combined into a single larger
packet, reducing network overhead and increasing data transfer performance.
Jumbo frames are supported on ports 1, 2, 3, and 4 only.
Select the Jumbo Frame check box to enable jumbo frames. By default, jumbo
frames are disabled.
Note: Jumbo frames are not supported on Fast Ethernet interfaces.
Table 31. Attack Checks screen settings for IPv4 (continued)
Setting Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
