IPv4 and IPv6 Internet and Broadband Settings
35
NETGEAR ProSAFE VPN Firewall FVS318G v2
10. Click the Apply button.
Your settings are saved.
11. To evaluate your entries, click the T
est button.
The VPN firewall attempts to make a connection according to the settings that you
en
tered.
12. T
o verify the connection, click the Broa
dband Status option arrow.
If your ISP requires MAC authentication and another MAC address was previously
registered with yo
ur ISP, you must enter that address on the Broadband Advanced
Options screen for the WAN interface (see Configure Advanced WAN Options and Other
Tasks on page 52
).
Configure Dynamic DNS
Dynamic DNS (DDNS) is an Internet service that allows devices with varying public IPv4
addresses to be located using Internet domain names. To use DDNS, you must set up an
account with a DDNS provider such as Dyn, TZO, Oray, or 3322. (Links to Dyn, TZO, Oray,
and 3322 are provided for your convenience as option arrows on the DDNS configuration
screens.) The VPN firewall firmware includes software that notifies DDNS servers of changes
in the WAN IP address so that the services running on this network can be accessed by
others on the Internet.
If your network uses a permanently assigned IP address, you can register a domain
name
and link that name with your IP address using public Domain Name Servers (DNS). However,
Use These DNS
Servers
If your ISP assigned DNS addresses, select the Use These DNS Servers radio
button. Make sure that you provide valid DNS server IP addresses in the fields.
Incorrect DNS entries might cause connectivity issues.
Primary DNS Server The IP address of the primary DNS server.
Secondary DNS Server The IP address of the secondary DNS server.
Table 5. DNS server settings (continued)
Setting Description
To Next Page
Loading...
Need help?
General
Weight and Dimensions
