Firewall Protection
150
NETGEAR ProSAFE VPN Firewall FVS318G v2
• WAN Users
Unless your selection from the Action
list is BLOCK always, you also must make
selections from the following lists:
• Select Sc
hedule
• QoS Priority
6. Click the Appl
y button.
Your changes are saved.
Create DMZ WAN Inbound Service Rules
The Inbound Services table lists all existing rules for inbound traffic. If you did not define any
rules, no rules are listed. By default, all inbound traffic (from the Internet to the DMZ) is
blocked.
Inbound rules that are configured on the LAN WAN Rules screen take
prece
dence over
inbound rules that are configured on the DMZ WAN Rules screen. As a result, if an inbound
packet matches an inbound rule on the LAN WAN Rules screen, it is not matched against the
inbound rules on the DMZ WAN Rules screen.
IPv4 DMZ WAN Inbound Service Rules
To create an IPv4 DMZ WAN inbound rule:
1. Log in to the unit:
a. In the address field of any of the qualified web browsers, enter
https://192.168.1.1.
The NETGEAR Configuration Manager Login screen displays.
b. In the User
name field, enter admin and in the Password / Passcode field, enter
password.
Use lowercase letters. If you changed the password, enter your persona
lized
password. Leave the domain as it is (geardomain).
c. Click
the L
ogin button.
The Router Status screen displays. After five minutes of inactivity,
which is the default
login time-out, you are automatically logged out.
2. Select Sec
uri
ty > Firewall > DMZ WAN Rules.
The DMZ WAN Rules screen displays. The IPv4 radio button is se
lected by default. The
screen displays the IPv4 settings.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
